China (Mainland)
Type HY-III (large) spraying room technology configuration table
Spray paint room inside diameter:
15000*5000*5000mm(L*W*H)
Spray paint room outside diameter
15144*6896*5600 mm(L*W*H)
Trench:
Dug two rows of pits, a single row of the pit size : 13 000 * 750mm(L*W)
Front door:
Single door, 4 door, 4000×4500mm(W*H)
Working door:
TWO,700*2000mm(W*H)
Wallboard:
Wall of the middle with three groups of steel ribs , top with three groups of steel composite beams , wall panels using thick 75mm , inside and outside the @= 0.476mm color steel plate , socket type , fill material : EPS
Lighting:
Discharge lamp group 18 * 3 = 54 branch of 36W lamp, with 14 * 4 = 56 36W vertical lumbar lamp
Rack device mode:
Lateral inlet air, exhaust air from back.Quadrate steel frame, the outer white mask, mask in galvanized steel sheet.
Supply and exhaust air base (2 units):
Selected with 4 sets of double inlet centrifugal fans , single wind turbine models and technical parameters are as follows : Model: YDW - 710H Power:5.5KW flow :20000
Heating system:
With two Italy Riyadh Road fuel burner, 2 stainless steel heat exchanger, 2 electric throttle execution spray paint circulation.Maximum heat output: 520000kcal / h
Filtration system:
Early effect filter , advanced filtering , glass cotton filter
Electronic control system:
Painting, heating of spray paint , paint , paint time setting , light switches, fault indicator , temperature controller, power switch, emergency stop switch , when tired , with a temperature limiter
Roof:
50mmEPS insulation roof
Maximum working temperature
60oc
Voltage frequency:
to be determined
No load speed
=0.25m/s
Light intensity:
=450LUX
Total power
40.5KW
Optional:
Color
blue,orange,gray
Large cabinet position
eft , right, rear
The real and the data is inconsistent, refer to the actual product.Products such as technical improvement without prior notice.